Keep it selected ..select the deformation tool

Now..using the deformation tool..rotate it by using the rotate in the center
of the square..also..stretch it a little by using the little box at the bottom
in the center..then move it till it's positioned like it is
in the image below. You can have a little of the top left underneath corner showing
but try not to get too much showing. Also.. look at where
the bottom comes to in this image..this needs to be about in the center
between the top and bottom..and the top of it needs to be above
the top of the drape underneath.

Now..double click on it and click "yes" to apply the deformation.
It should still be selected..go to Image..sharpen..and sharpen once.

At this point..you can still move it around a little to position it
if you need to..as long as you still have it selected.

When you get it where you want it..de-select it..then using the rectangle
selection tool..box in the area at the top where it comes above the bottom drapes.
Keep the box right on the top edge of the drapes below.
Like the image below..

Now hit Delete to delete the selection..then do the same at the
left side of the drapes.

Now it should look like this.

Now..go back to circle image and if you still have the selection that
you used before..then you can just copy it..if not then use your
ellipse selection tool to select an area again..like you did before.
Hit Ctrl C to copy it

Now..paste it on your drapes image ..place the top of it right where the
bottom of the top half is..and put the center right at the left edge of the
drapes underneath.
like this

Now..again..click the deformation tool..and just stretch the
length of it a little. You are stretching it because you want the bottom
center of it to be a little straighter..not so curved. The longer you stretch it
the straighter it will become at the bottom where we will cut it off.
But keep in mind that the more you stretch it the more it will blur it.

Now..double click it and click "yes" on apply deformation.
Keep it selected..go to Image...sharpes..and sharpen once.

Now..just like before..use your rectangle selection tool to select the area
that hangs over at the bottom and side and delete them.

Now it should look like this.

Now..using your rectangle selection tool..draw a big box around
all of the front drapes...like this

Now..click anywhere on the drapes in the box to select them.

Keep them selected..go to Image..Drop Shadow..and add a drop shadow.
I used the same settings as earlier.

Keep them selected..hit Ctrl C to copy them..then Ctrl E to paste them on the
same image...
Keep the new copy selected..go to Image..Mirror..and position them
on the right side where you want them..
Like this..

NEXT PAGE